KN95 Face Mask

Product General Information

Parts List

Product(s) Dimension

Easy to Use/Donning and fitting

1) Hold the mask in hand with the nose bar up. Allow ear loop to hang freely.

2) Position the mask under the chin covering mouth and nose.

3) Pull the ear loop to the ear and adjust the ear loop to feel as comfortable as possible. 

4) Press soft nose bar to conform snugly around the nose. To check fit, cup both hands over the mask and exhale vigorously. If air flows around nose, tighten the nose bar. If air leaks around the edge, reposition the ear loop for better fit. Re-check the seal and repeat the procedure until the mask is sealed properly.

5)Change the mask immediately if breathing becomes difficult or mask becomes damaged or distorted.

6) Change the mask if proper face seal cannot be achieved 

7) Carefully observe these instructions is an important step in safe use

Warnings

Failure to follow all instructions and limitations on the use of this product, or failure to achieve proper fit, may result in damage to your health or death or will not provide the expected level of protection

This product does not supply oxygen. Use only in adequately ventilated areas containing sufficient oxygen to support life. Do not use this respirator when the oxygen concentration is less than 19.5%.

Do not use when concentrations of contaminants are immediately dangerous to health or life. Do not use this product in an explosive atmosphere.

Facial hair, beards and certain facial characteristics may reduce the effectiveness of this respirator.

“NR” means non reusable, this particle filtering half mask shall not be used for more than one shift. The length of time this respirator can be used depends on contaminants present but should not exceed one shift. The respirator should be replaced sooner if breathing becomes difficult.

 Respirator should be discarded after use or when it becomes damaged or deformed in any way; no longer forms an effective seal to the face; becomes wet or visibly dirty; breathing becomes difficult.

The respirators must be stored and transported in their original package and protected by the storage temperature and humidity as suggested by the manufacturer